Warning! This system board does not support the power requirements of the installed processor. The user needs to replace the faulty part and restart the system. Halt - The message appears on the screen, an error is logged to the SEL, and the system cannot boot unless the error is resolved.The user can take immediate corrective action or choose to continue booting. Pause - The message appears on the screen, an error is logged to the SEL, and user input is required to continue.The system continues booting with a degraded state. An error record is logged to the system event log (SEL). Warning or Not an Error - The message appears on the screen.The Response column describes the action taken by the system on encountering the corresponding error.
#Intel processor diagnostic tool fail imc code#
You can see some of the POST codes from primary I/O port 80 on LEDs inside the front panel of your server node (see POST Code LEDs). In the POST codes listed in TABLE 8-1, the first two digits are from port 81 and the last two digits are from port 80. These POST codes appear at the bottom right of the BIOS screen as a four-digit string that is a combination of two-digit output from primary I/O port 80 and two-digit output from secondary I/O port 81. TABLE 8-1 contains descriptions of each of the POST codes, listed in the same order in which they are generated. On-board IB gPXE Boot First: Sets the on-board infiniband gPXE to always boot first.The system pauses if an error is found during POST and only resumes when you press the F1 key. Wait for F1 if Error: This option is enabled by default.If you enable this option, the Sun Microsystems logo appears instead of POST codes.
Initialize the BIOS Setup Utility by pressing the F2 key while the system is performing the power-on self-test (POST). These instructions are optional, but you can use them to change the operations that the server performs during POST testing.ġ.
0 kommentar(er)
